Running The Replication Wizard; Replication Creation Process - HP StorageWorks D2D - Backup Systems User Manual

Running the replication wizard

The Replication Wizard is used to create new mappings between Non-Replicating Libraries (which
become Replication Source Libraries) and either existing or new Target Libraries. (See
"Recovering a source
Create non-replicating Library on source appliance
Create backup rotation scheme and allow first full
On the Mapping Configuration page select the
non-replicating library on the source appliance.
1. Select Start Replication Wizard.
2. Select the target appliance (or create a new one).
3. Select the target library (or create a new one).
4. Edit slot mapping name and map required slots
between source and target.
5. Confirm and finish configuration.
Replication of cartridges will now start.
When cartridges are synchronized, relocate target
appliance to target site.
Figure 46 Replication creation process
1.
Create a Non-Replicating Library on the Source Appliance.
2.
Create a backup rotation scheme and allow the first full backup to run.
90 Configuring and using replication
appliance" on page 94 for information about the Recovery wizard.)
Start
backup to run
Use physical
tape media for
seeding?
Yes
Was target
co-located with
source?
Yes
End
No
No