HP StorageWorks D2D - Backup Systems User Manual page 41

2. Select Start the wizard and follow the onscreen instructions to step through the installation,
normally by pressing Next.
The Installation wizard will, if possible, configure all the software components required for setup
and use of the HP D2D Backup System. Use the Wizard help if you need more information.
• Install drivers: These allow your system to recognize the tape medium changer and drive
devices created on the HP D2D Backup System.
• Discover network devices: This allows you to locate your HP D2D Backup System on the network
and configure network settings. If you have multiple devices on your network, a list is displayed
so that you can select the required HP D2D Backup System.
If the Discovery process does not find your appliance and you are accessing through a firewall,
you may need to temporarily disable the firewall or open UDP ports 8105 and 8106 and
retry.
When the configuration page for the device is displayed, DHCP is enabled by default for
IPv4 networks. If you wish to use static IP addressing, disable DHCP and enter the IP address
details.
D2D Backup System HP D2D4112 41