Installation Guidelines; Mounting The Server - HP StorageWorks D2D - Backup Systems User Manual

Installation guidelines

This installation is to be performed by qualified individuals who have knowledge of the procedures,
precautions, and hazards associated with equipment containing hazardous electrical circuits.
WARNING!
These rails, when installed, form only a shelf for the server to rest on. The server is not attached to the
rail by any other means. Use extreme caution when pulling the server out from the rack; it can slip
and fall, causing damage to the server or injury. HP is not responsible for any damage or injury
caused by the mishandling of the server.
WARNING!
Ensure that the rack is level and stable before working on the rack. Be sure the leveling jacks (feet)
extend to the floor and that the full weight of the rack rests firmly on the floor.
WARNING!
Ensure that the rack has anti-tip measures in place. Such measures may include floor-bolting, anti-tip
feet, ballast, or a combination of these as specified by the rack manufacturer and applicable codes.
WARNING!
Ensure that sufficient personnel are on hand to support the product(s) during the installation process.
Use of the appropriate lifting device is recommended as an installation aid.
WARNING!
Always load the rack from the bottom up. Load the heaviest items in the rack first. This makes the
rack bottom-heavy and helps prevent it from becoming unstable.
WARNING!
Do not overload the branch circuit that provides power to the rack. The total rack load should not
exceed 80 percent of the branch circuit rating.

Mounting the server

1. Position left and right rack rails at the desired 'U' position in the rack.
32 Connecting and installing the HP D2D Backup System