To Move Or Unload Cartridges; Network (Configuration); To Edit Network Settings - HP StorageWorks D2D - Backup Systems User Manual

To move or unload cartridges

The ability to move cartridges is provided, but only to an empty Location (mail slot, tape drive or
numbered slot). The Move Cartridge drop-down menu lists available empty slots. (Empty numbered
slots are created if you delete a cartridge.)
Use the Unload all Cartridges button to return all cartridges to their slots.
The move and unload options are unlikely to be required very often, but may be useful if the user
needs to re-align their library configuration against their backup application should they become out
of synch, perhaps because the backup application has crashed, or if the backup application does
not support the Move Medium command.

Network (Configuration)

This page is used to view and edit network settings. It is also used to turn Beacon Mode on and off.
Network configuration
The details in this section reflect the IP settings that were specified during installation. The HP D2D
Backup System supports DHCP for IPv4 networks and this is turned on by default.
You may need to edit the details if there is a conflict in the IP address, or you move the host to a
different network node. Be aware that any changes you make to the network settings could affect
how you connect again to the HP D2D Backup System. For example, if you change the IP address,
you must use the new address to log in from a web browser.

To edit network settings

1. Click Edit to make the details editable.
2. Make the required changes and click Update.
120 The Web Management Interface