Staple Cartridge Replacement - Sharp AR-C330 Operation Manual

FINISHER (AR-FN4)

Staple cartridge replacement

When the staple cartridge is empty, the message "SLIDE THE
FINISHER AWAY FROM THE COPIER AND ADD STAPLES." will
appear.
Replace the staple as follows:
7-22
While holding the finisher release lever, slide the finisher
1
away from the copier.
Pull out the staple box.
2
q
To prevent bumping or scraping your hand during removal of the
staple box, proceed as shown in the illustration and as follows:
Grasp the staple box with your thumb and index finger, and place
the heel of your hand against the finisher frame as shown with
arrow in the illustration.
1
Remove the staple box in the direction of the arrow
squeezing with your fingers and rotating against the heel of your
hand.
Remove the empty staple cartridge from inside the
3
staple box.
Insert the new staple cartridge into the box until it clicks
4
in place.
q
Insert the new cartridge by aligning the arrows on the cartridge
with those on the box. Check that the cartridge locks in place by
pulling it slightly.
q
The cartridge holds 3,000 staples.
NOTE:
Be sure to remove the rear paper and tape before inserting the
cartridge.
by
2