Table of Contents
Advertisement
FINISHER (AR-FN4)
Offset stack
In the initial settings, the offset stack function is set to off. To enable
the offset stack function, press the "OUTPUT" key and then touch the
"OFFSET" icon on the touch panel. To disable the "OFFSET"
function, press the "OUTPUT" key and then touch the "NON
OFFSET" icon. When the offset function is selected, the output tray
will move side to side each time a set is output so that each set is
offset by approximately 20 mm (0.8 inches) from the previous set.
NOTE:
Some type or quality of paper might cause tight curl when it is output.
In this case, remove the paper out of the paper tray or the bypass tray
and reload it upside down.
READY TO COPY.
OUTPUT
NON OFFSET
A4
AUTO
AUTO
EXPOSURE
PAPER SELECT
READY TO COPY.
OUTPUT
NON OFFSET
A4
AUTO
AUTO
EXPOSURE
PAPER SELECT
7-20
OFFSET mode
When making copies, the output tray will shift from its
previous position by approximately 20 mm (0.8 inches)
OK
each time a "START" key is pressed. In this way, the set in
progress will be offset from the previous set. Copies in the
size of A5, A4, A4R, B5, 216mm x 330mm, B4, and A3 (5-1/2"
OFFSET
x 8-1/2", 8-1/2" x 11", 8-1/2" x 11"R, 8-1/2" x 13", 8-1/2" x 14",
and 11"x 17") can be offset.
100%
COPY RATIO
NON OFFSET mode
All copies will be aligned in one stack in the tray with no
offset.
OK
OFFSET
100%
COPY RATIO
Advertisement
Table of Contents
Troubleshooting
