Table of Contents
Advertisement
Plug the copier into a grounded outlet and turn the
power switch on. Then, follow the procedure below.
7. Set the mode.
•
Operate the copier keys to set the mode.
C
0/
The above key operation will display the currently set mode.
•
When only the SF-A56 is to be set, immediately after the above
key operation, operate the keys as follows:
0/
1
•
If the mode is to be set in combination with other options, use the
table shown below to add up the total of the setting values for all
the peripheral devices to be set, and set that total value.
For example, if the SF-A56 and sorter are to be set, the total
setting value is 1 + 10 = 11. Operate the keys as follows:
1
1
SF-A17
1
Stand/paper drawer
SF-A56
1
8. Adjust the center of the copy.
Set an original in the ADF tray and make a copy.
When the copy is off center as shown in Fig. 1 or Fig. 2, loosen the
two tray securing screws and adjust the tray by moving it in direction
A orB as shown in the figure.
Mark
B
2
6
0/
1
4
Sorter
Staple sorter
Tray securing screw
A
When off center as shown in fig. 1
Move the tray in direction A and secure it with the two mounting
screws. Make a copy to check whether it is centered properly.
Fig. 1
When off center as shown in fig. 2
Move the tray in direction B and secure it with the two mounting
screws. Make a copy to check whether it is centered properly.
Fig. 2
9. Adjust the position of the leading edge of
originals
•
The position of the leading edge of originals fed from the ADF can
10
be determined using test command 53 .
10
•
Although the leading edge has been factory set to stop at location
(8), it may need to be adjusted depending on the type of originals.
The leading edge position can be adjusted within a range of 8 mm
(8 steps) on the stopper side and 7 mm (7 steps) on the glass side
in 1 mm increments. Adjustment can be done separately for the
one-sided, two-sided, and thin paper modes.
0
1
2
3
4
8 mm
Stopper
Setup example
(1) If the leading edge of the original was not fed all
stopper, enter value which will
stopper side.
7, 6, 5, 4...
Stopper
5 – 12
Center of copy paper
Center of original image (first copy)
Center of copy paper
Center of original image (first copy)
8
5
6
7
9
10 11 12 13 14 15
7 mm
Glass
View from the operator side
move the original toward the
Original
Glass
the way to the
Advertisement
Table of Contents
