Table of Contents
Advertisement
Displaying the Date and Time
of Recording
Available modes: all modes
Follow the procedure below to display the date,
or both the date and time, of recording on the
screen. You can display the date and time
during both recording and playback.
1
Display the menu screen (see page 31).
2
Touch [K] or [L] to select "Y", and
then touch [SET]. Touch [K] or [L] to
select "DISPLAY", and then touch [SET].
3
Touch [K] or [L] to select "DATE" or
"DATE+TIME", and then touch [SET].
D I SP L A Y
4
Touch [RETURN] until the menu screen
turns off.
• The date (or the date and time) is
displayed.
I NDE X
MENU
RE -
TURN
Notes:
• Before recording, make sure that the date and
time have been correctly set (see pages 17 and
18). If they have not been set, the display will be
left blank when playing back the recording. (The
display will also be left blank for unrecorded or
damaged portions of the tape.)
• In TAPE-VCR mode, the current date and time
are displayed when the tape is not being played
back.
C L O CK S E T
D I S P L A Y
OF F
DA T E
R E T URN
DA T E + T I ME
S E T
RE -
TURN
DA T E + T I ME
2 . 6 . 2 0 0 2
1 0 : 3 0
6 0min
Using Earphones (Commer-
cially Available)
Available modes: TAPE-VCR, TAPE-CAMERA,
DUAL-CAMERA
You can monitor the sound via stereo ear-
phones (commercially available) during
playback or recording. Stereo earphones with a
3.5 mm diameter plug can be connected to the
camcorder.
Open the jack cover, and connect stereo
earphones to the PHONES jack.
PHONES jack
Notes:
• Before connecting stereo earphones, turn the
camcorder volume down to the lowest setting.
• The built-in speaker automatically turns off when
stereo earphones are connected to the PHONES
jack.
• When recording, you cannot adjust the volume
with the Power Zoom/VOL. buttons on the
camcorder. Use the VOL. buttons on the infrared
remote control instead.
50
E
Advertisement
Table of Contents
