Preparation; Charging The Battery Pack; Preparation Charging The Battery Pack - Sharp ViewCam Slim VL-ME100E Operation Manual

Liquid crystal display camcorder
Table of Contents

Advertisement

Preparation

Preparation

Charging the Battery Pack

Charge the battery pack with the supplied AC
adapter/battery charger before use.
Note:
• Remove the DC cable from the AC adapter/
battery charger when charging the battery pack.
1
Connect the supplied power cord to the
AC power socket on the AC adapter/
battery charger, and insert the AC plug
into a power outlet.
• The POWER indicator lights up.
POWER indicator
2
Align the d mark on the battery pack
with the f mark on the charger (1) and
guide the battery into the groove.
Pressing the battery (2), slide it in the
direction of the arrow (3) until it locks
into place.
• The CHARGE indicator lights up.
1
• The CHARGE indicator goes off when
the battery is fully charged.
3
Slide the battery pack in the direction of
the arrow (1), and remove it (2). Then,
remove the AC plug of the power cord
from the power outlet.
11
E
AC power socket
To power
outlet
2
3
CHARGE indicator
2
1
Charging time and maximum continuous
recording and playback times in TAPE
modes
Battery
Charging
recording time
pack
time
closed
BT-LS222
100
BT-L221
160
BT-L441
190
BT-LS442A
• The chart specifies the approximate times in
minutes.
Notes:
• Charge the battery pack between 10°C and
30°C. The battery pack may not charge
properly at temperatures too low or too high.
• The battery pack and charger become warm
during charging. This is not a malfunction.
• Using the zoom (see page 23) and other
functions or turning the power on and off
frequently will increase power consumption.
This may result in a decrease of more than
50% in the actual recording time compared to
the maximum continuous recording time
listed above.
• The charging time and recording time may
vary depending on the ambient temperature
and the condition of the battery pack.
• Even when the battery pack is not used, the
capacity of the battery pack will naturally
deteriorate over time. To limit deterioration of the
battery pack capacity, perform the procedure in
"Extending battery pack life" on page 110 at
least once every six months.
• See pages 109 and 110 for more information on
using the battery pack.
Caution:
• Charge only SHARP model BT-LS222, BT-L221,
BT-L441, or BT-LS442A battery packs. Other
types of battery packs may burst, causing
personal injury and damage.
Max.
Max.
continuous
continuous
playback
time
LCD
LCD
on LCD
open
110
90
90
220
180
180
260
220
220

Advertisement

Table of Contents
loading

Table of Contents