Table of Contents
Advertisement
Dew Formation
• What is "dew formation"?
When cold water is poured into a glass, dew
drops form on the glass. This clinging of
water drops is called dew formation.
• When dew forms in your camcorder.
Dew will gradually form on the head drum of
your camcorder and make the video tape
stick to the head. This causes damage both
to the head and the tape. When dew forma-
tion occurs, recording and playback may not
function properly.
Dew is likely to form in the following circum-
stances:
—When moving the camcorder from a cold
place to a warm place.
—When placing the camcorder in a cold
room which is then heated rapidly.
—When moving the camcorder outdoors from
an air conditioned room.
—When placing the camcorder in the direct
path of air blowing from
an air conditioner.
—When placing the
camcorder in a humid
room.
• How to prevent trouble due to dew
formation.
When using the camcorder in a place where
dew formation is likely to occur, allow the
camcorder and the video tape to acclimate to
the surroundings for about one hour.
For example, when bringing the camcorder
indoors after skiing, place it in a plastic bag.
Plastic bag
1 Be sure to tightly seal the plastic bag
containing the camcorder.
2 Remove the bag when the air temperature
inside it reaches the temperature of the
room.
• "Dew" warning feature
If dew forms, the word "DEW" flashes on the
screen, and the power will automatically turn
off in approximately 10 seconds.
1 If "DEW" flashes, remove the cassette,
leave the cassette compartment open,
and wait for a few hours to allow the
camcorder to acclimate to the surrounding
temperature.
2 To use the camcorder again, turn on the
power after waiting for a few hours. Be
sure that "DEW" has disappeared.
3 Do not insert a cassette while "DEW" is
flashing; this may result in damage to the
tape.
4 Since dew forms gradually, it may take 10
to 15 minutes before the dew warning
feature engages.
x
E
Advertisement
Table of Contents
