Editing With The Dv Terminal (Ieee1394); Power Switch - Sharp ViewCam Slim VL-ME100S Operation Manual

Editing with the DV Terminal
(IEEE1394)
Available mode: TAPE-VCR
This camcorder enables you to perform digital
video editing. Connect the camcorder to a
personal computer with an IEEE1394 port
using the supplied DV cable as shown below.
Note:
• For details on DV editing using a personal
computer with an IEEE1394 port, please see the
operation manuals for the personal computer
and editing software that you are using.
Personal computer
with IEEE1394 port
To IEEE1394 port
DV cable (supplied)
Notes:
• If no DV signal is output from the personal
computer or if the DV cable is not properly
connected, "NO SIGNAL" is displayed on the
camcorder screen.
• When no signal is input to the camcorder even if
the DV cable is properly connected and DV
signal is output from the personal computer, set
the POWER switch on the camcorder to OFF and
then back to VCR, or disconnect the DV cable
and connect it again.
• If a digital video recording with a copyright
protection signal is used as the playback source,
"COPYRIGHT PROTECTED." appears on the
camcorder screen and the recording function is
disabled (see page 107).
• There is other hardware besides a personal
computer to which this camcorder can be
connected with the DV cable for DV editing. For
details on connection and editing operations,
please see the operation manual for the
hardware in question.
To DV terminal
78