Charging The Battery Pack - Sharp ViewCam Slim VL-ME100S Operation Manual

Preparation
Preparation

Charging the Battery Pack

Charge the battery pack with the supplied AC
adapter/battery charger before use.
Note:
• Remove the DC cable from the AC adapter/
battery charger when charging the battery pack.
1
Connect the supplied power cord to the
AC power socket on the AC adapter/
battery charger, and insert the AC plug
into a power outlet.
• The POWER indicator lights up.
POWER indicator
2
Align the d mark on the battery pack
with the f mark on the charger (1) and
guide the battery into the groove.
Pressing the battery (2), slide it in the
direction of the arrow (3) until it locks
into place.
• The CHARGE indicator lights up.
1
CHARGE indicator
• The CHARGE indicator goes off when
the battery is fully charged.
3
Slide the battery pack in the direction of
the arrow (1), and remove it (2). Then,
remove the AC plug of the power cord
from the power outlet.
1
11
Charging time and maximum continuous
recording and playback times in TAPE
modes
• The chart specifies the approximate times in
AC power socket
Notes:
• Charge the battery pack between 10°C and
• The battery pack and charger become warm
To power
outlet
• Using the zoom (see page 23) and other
• The charging time and recording time may
2
• Even when the battery pack is not used, the
3
• See pages 105 and 106 for more information on
Caution:
• Charge only SHARP model BT-LS222, BT-L221,
2
Max.
continuous
recording time
Battery Charging
pack time
LCD
closed
BT-LS222
100 110
BT-L221
160 220
BT-L441
190 260
BT-LS442A
minutes.
30°C. The battery pack may not charge
properly at temperatures too low or too high.
during charging. This is not a malfunction.
functions or turning the power on and off
frequently will increase power consumption.
This may result in a decrease of more than
50% in the actual recording time compared to
the maximum continuous recording time
listed above.
vary depending on the ambient temperature
and the condition of the battery pack.
capacity of the battery pack will naturally
deteriorate over time. To limit deterioration of the
battery pack capacity, perform the procedure in
"Extending battery pack life" on page 106 at
least once every six months.
using the battery pack.
BT-L441, or BT-LS442A battery packs. Other
types of battery packs may burst, causing
personal injury and damage.
Max.
continuous
playback
time
LCD
on LCD
open
90 90
180
180
220 220