Editing - Sharp ViewCam Slim VL-ME100S Operation Manual

Advanced Features
Playback

Editing

Available mode: TAPE-VCR
Video editing lets you refine your videos by
removing unwanted sequences from your tape,
or transposing one sequence with another.
This camcorder lets you monitor the source
programme on the built-in LCD monitor without
having to connect it to an external TV or video
monitor.
Connect the camcorder to a VCR with the
supplied audio/video/S-video cable, as shown.
Recording
PAUSE
/STILL
PLAY
STOP/
EJECT
POWER
TV/VCR SET UP
To S-video
Yellow: To video input jack
input
White: To audio input (L) jack
terminal
Red: To audio input (R) jack
Audio/video/S-video
cable (supplied)
To AV+S terminal
Notes:
• If your VCR has a 21-pin Euro-SCART connector,
use the RCA/21-pin Euro-SCART conversion
connector (QSOCZ0033TAZZ).
21-pin Euro-SCART on VCR
0 RCA/21-pin Euro-SCART
conversion connector
(QSOCZ0033TAZZ)
VIDEO AUDIO AUDIO
(L/MONO) (R)
Audio R
Video
Audio L
• If your VCR has an S-video input terminal, you
can use the S-video plug of the supplied audio/
video/S-video cable for the video connection on
the VCR. (The yellow video plug does not need
to be connected to the VCR.)
• If your VCR has only one audio input jack, use
the white plug for the audio connection on the
VCR.
77
Cutting Unwanted Sequences
1
2
3
CHANNEL
REC
4
5
Playback
To stop editing
Touch [b] (Stop) on the [1/3] screen, and
press the Stop button on the VCR.
Notes:
• Some of the transitions between edited
• There may be picture noise during video search
• If the date and time and/or the time code are
• The camcorder cannot be used as the recording
Play back the tape to be edited on the
camcorder, and locate the beginning
and end of the sequence you wish to
cut. Write down the time code readings
at the beginning and end of that
sequence (see page 51). Then, rewind
the tape to before the beginning of the
portion that you wish to keep.
Load a video cassette into the recording
VCR.
Touch [PLAY/STILL] on the [1/3] screen
to begin playback, and then press the
Record button on the VCR to begin
recording.
Press the Pause/Still button on the VCR
to pause recording when the source
tape reaches the beginning of the
sequence to be cut.
Press the Pause/Still (or Record) button
on the VCR to resume recording when
the source tape reaches the end of the
sequence to be cut.
sequences may be slightly off.
or still playback. This does not imply a defect in
the camcorder.
displayed on the camcorder screen, they will be
recorded along with the edited sequences. Turn
them off if you do not want to record them on the
edited sequences (see pages 50 and 51).
source when editing analogue signals.