Sharp ViewCam Slim VL-ME100S Operation Manual page 65

Control Buttons on the Infrared Remote Control
TAPE REC START/STOP
button [pp. 22, 40]
CARD REC button [pp. 40, 84]
REW button [pp. 25, 26]
PAUSE/STILL button [p. 26]
STOP button [p. 25]
Playback Direction buttons
[p. 49]
Operating the Infrared Remote Control
1
Open the LCD monitor to a 90° angle to
the camcorder body (1), and then
rotate it 180° vertically (2).
180
2
90
1
2
Set the Media Selection switch on the
camcorder to TAPE, DUAL, or CARD.
3
Set the POWER switch on the camcorder
to CAMERA or VCR.
ZOOM T/W buttons [pp. 23, 54]
VOL. =/- buttons [p. 26]
PLAY button [p. 25]
FF button [pp. 25, 26]
SLOW button [p. 49]
Shift buttons [p. 54]
4
Aim the remote control transmitter at the
infrared remote sensor of the camcorder,
and press the control buttons for
operation.
Approximate operating
range of remote control
Transmitter
Notes:
• Be careful not to allow direct sunlight or bright
light from interior illumination to fall onto the
remote sensor, as this may prevent the remote
control from operating properly.
• Be sure that there are no obstacles between the
remote control and the remote sensor.
Infrared remote
sensor
48