Table of Contents
Advertisement
Preparation
Charging the Battery
Pack
1
Attach the battery pack on the
camcorder, and make sure that the
Power switch is set to OFF.
2
Open the DC IN jack cover.
3
Connect the supplied power cord
to the AC power socket on the AC
adapter, and insert the AC plug
into a power outlet.
AC power socket
4
Insert the DC plug into the DC IN
jack of the camcorder.
• The POWER/CHARGE (RED)
indicator lights up red.
• The POWER/CHARGE (RED)
indicator turns off when the battery is
8
charged.
DC IN jack cover
To power
outlet
POWER/CHARGE (RED)
indicator
DC IN jack
DC plug
5
Remove the DC plug from the DC IN
jack, then remove the AC adapter
from the power outlet.
Charging time and maximum
continuous recording and playback
times in Tape modes
continuous
Battery
recording time
Charging
time
pack
LCD
closed
BT-L226
120
115
• The chart specifies the approximate times in
minutes.
Notes:
• Charge the battery pack between 10°C and
30°C. The battery pack may not charge
properly at temperatures too low or too
high.
• The battery pack and AC adapter become
warm during charging. This is not a
malfunction.
• Using the zoom (see page 23) and other
functions or turning the power on and off
frequently will increase power consump-
tion. This may result in a decrease in the
actual recording time compared to the
maximum continuous recording time listed
above.
• The charging time and recording time may
vary depending on the ambient tempera-
ture and the condition of the battery pack.
• See pages 98 and 99 for more information on
using the battery pack.
• Charge only SHARP model BT-L226 battery
packs. Other types of battery packs may
burst, causing personal injury and damage.
• When attaching the supplied audio/video/S-
video cable or USB cable, remove the DC
plug, open the terminal cover and connect it.
Max.
Max.
continuous
playback time
LCD
on LCD
open
100
100
Advertisement
Table of Contents
