Setting The Printer Frame Type - Canon imagePROGRAF W7200 Network Manual

Setting the Printer Frame Type

Before setting the printer protocol, you must follow the procedure below to
set the printer frame type to enable communication between the computer in
use and the printer. Use the software application below to set the IP address.
•
Important
z The GARO Device Setup Utility must be installed on your computer in order to
use this utility to make the settings. Ask your system administrator to install the
GARO Device Setup Utility on your computer. (Æ Setup Guide)
z Before setting the Frame Type, confirm that the printer is switched on and
connected to the network.
z The MAC address is required to perform the setting with the GARO Device Setup
Utility. If you need to confirm the MAC address, use the printer operation panel to
print a Status Print.
GARO Device Setup Utility (Æ P.4-4)
1. Press ONLINE to display MAIN MENU.
2. Press or to select Test Print then press
3. Press or to select Status Print then press ENTER.
.
Setting the Printer Frame Type
4-3