Setting The Printer Ip Address - Canon imagePROGRAF W7200 Network Manual

Setting the Printer IP Address

Before setting the printer protocol, you must set the IP address to enable
communication between the printer and the computer. You can use one of the
methods below to set the IP address. Use whichever method is easiest:
•
•
•
Important
z When you use the GARO Device Setup Utility to perform the settings, you must
make the settings from a computer in the same subnet as the printer.
z When you use the GARO Device Setup Utility to perform the printer network
settings, the subnet mask and gateway address settings are set to 0.0.0.0, so use the
Remote UI or printer operation panel to make the settings for your network.
z If you are using an operating system that is not compatible with the GARO Device
Setup Utility, use another computer on the network, use the ARP/PING command,
or use the printer operation panel to perform the settings.
z The GARO Device Setup Utility must be installed on your computer in order to
use this utility to make the settings. Ask your system administrator to install the
GARO Device Setup Utility on your computer. (Æ Setup Guide)
z Before setting the IP address, confirm that the printer is switched on and connected
to the network.
z The MAC address is required to perform the setting with the GARO Device Setup
Utility or the ARP/PING command. If you need to confirm the MAC address, use
the printer operation panel to print a Status Print.
GARO Device Setup Utility (Æ P.2-4)
ARP/PING command (Æ P.2-6)
Printer operation panel (Æ Setup Guide, Chapter 2, "Doing the settings
on the Printer Operation Panel")
1. Press ONLINE to display MAIN MENU.
2. Press or to select Test Print then press
3. Press or to select Status Print then press ENTER.
.
Setting the Printer IP Address
2-3