Canon imagePROGRAF W7200 Network Manual page 65

Solution: Set the DIP SW on the back of the printer to the correct position for the
LAN in use. (Æ Setup Guide)
Problem 3: The NetWare
Solution: Check the following points:
• Make sure that the NetWare
• Make sure that sufficient disk space is available on the NetWare
server. If sufficient space is not available, then large print jobs cannot be
executed.
• Start NWADMIN or PCONSOLE and confirm (1) that the print service
is set correctly, and (2) that the print queue has been enabled for use.
(Æ P.4-6)
• Make sure that the network settings for the printer are correct. (Æ P.4-3,
P.4-11) Confirm that the frame type selection specifies an enabled frame
type.
Problem 4: The computer used to start the print job is not set up correctly.
Solution: Confirm the following points:
• Make sure that the correct printer driver has been installed. In order to
perform print jobs, the correct printer driver must be installed for each
operating system. (Æ Setup Guide)
• Make sure that correct printer port has been selected for the printer to be
used for printing. In the Control Panel open the Printer folder and then
check the connection with the Properties command in the File menu.
Problem 5: A print job data stream cannot be sent from the NetWare
printer in another subnet.
Solution: When a print job data stream is sent from the NetWare
sent in the NCP burst mode, and the data transfer to a printer on another
subnet may fail, depending on the network environment that you are using.
In this case, at the printer protocol setting, set the NCP burst mode to off.
Problem 6: When using the queue server mode, the printer type setting appears set for
Parallel.
Solution: Select Other/Unknown for the Printer Type setting.
®
network is not set correctly.
®
file server is running.
®
file
®
server to a
®
server, the data is
5-5
When You Cannot Print