When You Cannot Use Garo Device Setup Utility - Canon imagePROGRAF W7200 Network Manual

When You Cannot Use GARO Device Setup Utility

GARO Device Setup Utility does not recognize printer
Problem 1: The printer is not switched on.
Solution:
Problem 2: The printer LAN port and cable are not connected correctly.
Solution:
Problem 3: The printer cannot recognize automatically the LAN communication
Solution:
Problem 4: The computer and printer are not in the same subnet.
Solution:
5-2
Troubleshooting
This section describes how to solve problems with the GARO Device Setup
Utility.
Check the printer power cord connection and the connection to the power
source, then press the POWER button on the printer.
Confirm that the connection of the cable that connects the printer to the
network is secure, then press the POWER button to cycle the printer off
and on again. (Æ Setup Guide).
method.
Set the DIP SW on the back of the printer to the correct position for the
LAN in use. (Æ Setup Guide)
Install the GARO Device Setup Utility on the computer in the same subnet
as the printer, then perform the network settings. For details about the
computer network settings, contact your system administrator.