Setting Netware ® Printer Protocol; Setting Up With A Web Browser (Remote Ui) - Canon imagePROGRAF W7200 Network Manual

Setting NetWare
To perform the printer protocol settings, use your Web browser on your
computer with the Remote UI, the software built into the network interface.
Perform the protocol settings on Web browser, after you finish setting the IP
address for the printer on the operation panel. (Æ Setup Guide, Chapter 2,
"Setting the Printer Network Information")

Setting up with a Web Browser (Remote UI)

1
Start the Web Browser, enter the following URL for the Address, then
press the Enter key.
http://<Printer IP address or name>/
Example: http://172.20.88.196/
Important
z For the Web Browser, use Netscape Navigator/Communicator 4.04 or later, or use
Internet Explorer 4.01SP1 or later. However, Netscape Navigator Version 6 or later
is not compatible.
z A connection through a Proxy Server cannot be used. If you are using a network
environment with a Proxy Server, use the "Proxies" server setting in the Web
Browser to add the printer IP address to the "Exceptions" text box (the address not
used by the Proxy Server). (Performing this setting may differ, depending on the
network environment.)
z Use the Web Browser to enable JavaScript and Cookie so these features can be
used.
z If more than one Remote UI is being used, then the most recently used settings
remain enabled. Starting and using only one Remote UI at a time is recommended.
®
Printer Protocol
®
Setting NetWare Printer Protocol
4-11