Xerox FreeFlow Operator And Administrator Manual page 127

F r e e F l o w P r o c e s s M a n a g e r O p e r a t o r a n d A d m i n i s t r a t o r G u i d e
4. In the Size area, specify the following:
• Font Size: Select or type the desired "font size." This is an
approximation of the width of the narrowest bar in the bar
code in "mils" (one thousandths of an inch). The Bar
Codes node does not require you to have bar code fonts
installed on the FreeFlow system.
• Height: Select or type the desired barcode height.
NOTE: The size of the human-readable text is not included in
the requested bar code height. If you specify height = 1 inch,
the total size of the graphic is one inch plus the height of the
readable text extending above or below the bar code.
NOTE: Height can be specified in inches or millimeters,
except for PostNet (Japan) and QR Code because the height
for those types is determined uniquely to bar width or cell size.
• Horizontal padding: Select or type the desired padding to
control the amount of white space on either side of the
barcode.
• Vertical padding: Available for QR Code type only. Select
or type the desired padding to control the amount of white
space at the top or the bottom of the barcode.
5. Select the desired degree of rotation, in increments of 90
degrees. The icon changes to reflect the selected rotation.
6. Select or type the horizontal position from the PDF document
box: [From left], [Center], or [From right].
7. Select or type the vertical position from the PDF document
box: [From top], [Center], or [From bottom].
8. Select the position relative to [Crop Box], [Media Box],
[Bleed Box], [Trim Box] or [Art Box].
NOTE: You can specify offset in inches or in millimeters either
as positive (inward from the selected box), or negative
(outward from the selected box) numbers. Default placement
is Top-Left of the Crop Box, with horizontal and vertical offsets
(0.0, 0.0).
Wo r k f l o w B u i l d e r
2-75