Cutting Fluid System
Figure 93
Figure 93.
Cutting Fluid System Service
Workpiece
General Note: Cutting fluids are used for heavy-duty lathe operations and production turning. Oil-water emulsions and synthetic
cutting fluids are the most common for typical lathe operations. Sulferized oils often are used for threading. For small projects,
spot lubrications can be done with an oil can or brush, or omitted completely.
ON
Page 69
Water
Dry
Soluble Oil
BIOLOGICAL & POISON
Use the correct person-
al protection equipment
when handling cutting
fluid.
state, and fluid manu-
facturer
for proper disposal.
NOTICE
Running the cutting fluid pump without
adequate fluid in the reservoir may perma-
nently damage it, which will not be covered
under warranty.
To use the cutting fluid system:
1.
2.
3.
Important:
Synthetic
Sulferized Oil
Fluids
HAZARD!
Follow
federal,
requirements
ON
Mineral Oil