Changing Cutting Fluid - Grizzly G9730 Owner's Manual

Changing Cutting Fluid

Items Needed
To change the cutting fluid:
1.
2.
3.
OFF
NOTICE
Running the cutting fluid pump without
adequate fluid in the reservoir may perma-
nently damage it, which will not be covered
under warranty.
Qty
ON
4.
5.
6.
7.
Tip: Leave one or more magnets at the bot-
tom of the reservoir to collect metal chips
and make cleanup easier next time. This will
also help keep small metal chips out of the
pump.
8.
9.
10.
11.
OFF
Note: It may take a few seconds for the pump
to start circulating the fluid. If the fluid does
not start flowing within the first minute, turn
the pump OFF to prevent damaging it. Try
priming the pump manually by pouring cutting
fluid down into the nozzle, then repeat Step
11.
ON