Preparation Of Needle Bar Case - Brother BES-1260BC Instruction Manual

2-3 Preparation of needle bar case

BES-960BC
1. Loosen the bolt q, and move the needle case w to the left.
2. Press the change bracket collar r against the change case base e on the light, while pressing
the change bracket collar t against the change case base y on the left, and tighten the bolt
q. Check that needles at needle bar No.1 and 9 are inserted into the needle plate holes
smoothly.
Notes) • Check that the connecting shaft u does not have backlash in the horizontal direction.
• If the bolt i of the change bracket collar on the right is loosened, it may be dislocated during adjust-
ment of the needle bar case w. Do not loosen this bolt.
BES-960BC BES-1260BC
Chapter 2 Preparation of Embroidery Machine
31