Preparation Of Needle Bar Case - Brother BES-1261BC Instruction Manual

Chapter 1 Preparation of Embroidery Machine

3-3 Preparation of Needle Bar Case

BES-961BC
1. Loosen the bolt q, and move the needle case w to the left.
2. Press the change bracket collar r against the change case base e on the light, while pressing
the change bracket collar t against the change case base y on the left, and tighten the bolt
q. Check that needles at needle bar No.1 and 9 are inserted into the needle plate holes
smoothly.
• Check that the connecting shaft u does not have backlash in the horizontal direction.
Note)
• If the bolt i of the change bracket collar on the right is loosened, it may be dislocated during adjust-
ment of the needle bar case w. Do not loosen this bolt.
24
w
y
q
u
t
BES-961BC BES-1261BC
e
i
r