Brother BES-1260BC Instruction Manual page 47

Chapter 2 Preparation of Embroidery Machine
6. Check that the clearance between the Y-axis cover u and the mounted holder base frames L
e and R t is even when viewed from the right and left sides.
Loosen the right and left bolts of the F table guide U i and move it in the direction of arrow for
[Adjustment]
adjustment.
7. Tighten each bolt securely after adjustment is finished.
Attaching the holder base
1. Mount the holder base mounting frame e on the X-axis feed frame q and holder base frame
C w, using three clamp screws.
2. When the mounting pitch of the holder base is 370 mm, mount the holder base horizontally to
the holder base mounting frames e using the thumb bolts r.
52
q
w
BES-960BC BES-1260BC
r
e