Brother BES-1260BC Instruction Manual page 51

Chapter 2 Preparation of Embroidery Machine
4. Set the needle bar case at the needle bar No. 1. Remove the presser foot r from the retracted
machine bed.
Note) • The head of the retracted bed is stopped.
• When removing the presser foot, align the pulley indication mark
• To operate the machine in retract position, set the bed in contact with the legs.
Resetting of bed retract
1. Move the machine bed e little by little until it comes into contact with the bed support q.
2. Loosen two bolts w and insert the bed into the right and left directions, then tighten the bolts
securely again.
3. Mount the presser foot for the reset bed e.
(Refer to "Chapter 10. Standard Adjustment" for mounting the presser foot.)
56 BES-960BC BES-1260BC
first.