Chapter 2 Preparation of Embroidery Machine
i
t
y
4. Mount four thumb bolts i each on the rear of F table R t, M (2 pcs.) y, and L u.
5. Mount five thumb bolts on the steel pipe below the front leg.
6. Insert the pins attached to the rear of the F table R t, M (2 pcs.) y, and L u into the cover o
on the leg. Adjust the height of the F table guide U q and the F table support F e so that the
table top surface will become 1 mm lower than the bed top surface. After adjustment is
finished, tighten each bolt securely.
34
u
Lower by 1 mm
BES-960BC BES-1260BC
o
Pin
q
e