Operating Procedures; Power Source; Preparation For Embroidering - Brother BES-1260BC Instruction Manual

Chapter 7 Operation of Machine

1. Operating Procedures

1-1 Power Source

1-2 Preparation for Embroidering

• Select embroidering data while the machine is in the waiting state for an embroidering data
selection, and transmit required data by pressing the
• The READY lamp lights up and the machine is placed in the waiting state.
• Using the jog switches (
Note) An error code is displayed in the display window if a pattern comes out of the hoop.
• Pressing the START switch starts embroidering.
START
* During embroidering, the speed is indicated in the display window.
• After embroidering is finished, the hoop returns to the start point and the machine is placed
in the stand-by state.
176
• Turn the power on to the machine.
• The power lamp lights up and the display
window indicates "BES-", and then "960".
• An alarm buzzer sounds three times. Then
the needle bar and presser foot move up
and the frame moves up to the reference
point.
The machine enters the waiting state for an
embroidering data selection.
Note) When turning the power off and back it on
), determine a position to start embroidering.
BES-960BC BES-1260BC
again, wait for at least 10 seconds.
icon.