Area Check; External Tracing; Automatic Hoop Movement In Area - Brother BES-1260BC Instruction Manual

9 needles/12 needles
Hide thumbs Also See for BES-1260BC:
Table of Contents

Advertisement

Chapter 7 Operation of Machine

7. Area Check

7-1 External Tracing

7-2 Automatic Hoop Movement in Area

0.1mm
Embroidering area
• If "area over" is displayed, press the check switch. The hoop automatically moves inside the
embroidering area, where the pattern is set, at the nearest position.
Note) After finishing the movement inside the area by this function, execute external tracing. Then, check that
the needle and the presser foot do not interfere with the hoop before starting embroidering.
Embroidering area
If the pattern is not held in the embroidering area as shown below, the hoop cannot move into the area.
Enlarge the embroidering area on the personal computer.
182
Embroidering
start position
(Example)
0.1mm
BES-960BC BES-1260BC
• If the check switch is pressed in other
cases than "area over", the rectangular
outline of the pattern is traced.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bes-960bc

Table of Contents