Cabletron Systems Fast Network 10 User Manual page 87

For example, if you had the configuration shown below, the And operator
assigned to Port 2 would apply to the next instance of Port 2, not
necessarily the next sequential filter number in the Port Filter Table index.
The Port filter configuration fields are described in Table 5-2.
Field Description
If the filter is for port 1, you do not need to enter
Port anything. If the filter is for another port, enter that
number.
Either Entry
Type on the port, or Exit
transmitting the packet from the port.
Either NA (not applicable), True
Port/ the receiving port or group number matches, or False
–
Group filter the packet if the receiving port or group number
Match does not match. This is valid only if the filter type is
Exit.
Decimal value for the number of the port or group
Port/ through which the packet entered the FN10 XE. This is
Group # valid only if the filter type is Exit. Port group numbers
start at 25.
Either NA (not applicable), True
Source the source MAC address is within the range, or False
–
Range filter the packet if the source MAC address is
outside of the range.
Fast Network 10 User Guide
Filter Filter
Index Port
1 1
2 2
3 1
4 2
5 2
Table 5-2 Port Filter Configuration Fields
–
apply the filter to all packets received
–
Filter
Operator
Or
And
Or
Or
Or
apply the filter before
–
filter the packet if
–
filter the packet if
Port Filters
Default
1
Entry
NA
NA
NA
Page 5-7