Setting A Reboot Time - Cabletron Systems Fast Network 10 User Manual

To display the current baud rate setting, at the LCM prompt:
1. Type
baud
LCM responds:
Usage: baud [1200|2400|4800|9600|19200]
To change the baud rate setting, at the LCM prompt:
1. Type
baud <baud rate>
For example,
LCM responds:

4.5.6 Setting a Reboot Time

You can enter the number of seconds the FN10 waits before rebooting. At
the LCM prompt:
1. Type
reboot <time interval>
For example,
reboot 60
LCM responds:
Fast Network 10 User Guide
Baud rate is 4800.
would set the baud rate to 9600.
baud 9600
Baud rate is 9600.
System will be reset in 60 seconds.
Using LCM to Manage the FN10
Page 4-19