Changing A Community Name; Setting The Baud Rate - Cabletron Systems Fast Network 10 User Manual

Chapter 4: Monitoring and Managing Your FN10

4.5.4 Changing a Community Name

A community name is similar to a password. You use the same steps to
assign a new community name or to change an existing community name.
This sets the MIB variable
community name to perform any
To assign a community name, at the LCM prompt:
1. Type
community
2. Enter the old community name.
If one has not been assigned, you do not need to enter anything. LCM
prompts you for the new community name.
3. Enter the new community name.
LCM prompts you to verify the new community name by retyping it.
4. Retype the new community name.

4.5.5 Setting the Baud Rate

You can set the baud rate for your LCM console connection. The options
for baud rate include:
• 1200
• 2400
• 4800
• 9600
• 19200
The default rate is 9600.
Make sure that the baud rate you set matches the baud rate
NOTE
setting for the terminal you are using.
Page 4-18
sxadminAnyPass
sets.
SNMP
. You can then enter a
Fast Network 10 User Guide