Cabletron Systems Fast Network 10 User Manual page 55

The LCM commands used to create the previous configuration are as
follows:
1. To create workgroup A on ports 3, 4, 5, 13, and 16:
FN10 > workgroup A 3-5,13,16
LCM responds with the following display:
Name: a
Ports: 3, 4, 5, 13, 16
Info: all
2. To create workgroup B on ports 7, 11, 16, and 24:
FN10 > workgroup B 7,11,16,24
LCM responds with the following display:
Name: b
Ports: 7, 11, 16, 24
Info: all
Port 16 has been assigned to a segment that includes hosts that belong to
workgroup A and workgroup B. Port 13 connects workgroup A to the
router and port 24 connects workgroup B to the router.
In the above steps, both command lines did not specify a specific
classification of workgroup and have defaulted to the all category that
allows broadcasts of any protocol. To specify a specific IP network you
would need to add the IP network ID.
The following LCM commands re-define the previous example as
workgroups with an IP network classification:
1. To create workgroup A:
FN10 > workgroup A 3-5,13,16 ip 198.113.120.0
LCM responds with the following display:
Name: a
Ports: 3, 4, 5, 13, 16
Info: IP 198.113.120.0 255.255.255.0
Fast Network 10 User Guide
Defining and Deleting Workgroups
Page 3-13