Assigning A Community Name - Cabletron Systems Fast Network 10 User Manual

To delete a workgroup, at the LCM prompt:
1. Type
workgroup NAME delete
To create or modify the port list for a specific workgroup, at the LCM
prompt:
1. Type
workgroup NAME PORT-RANGE
To modify the network classification of a specific workgroup, at the LCM
prompt:
1. Type
workgroup NAME INFO

3.9 ASSIGNING A COMMUNITY NAME

A community name is similar to a password. You use the same steps to
assign a new community name or to change an existing community name.
This sets the MIB variable
community name to perform any
empty string that allows you to enter your community name.
To assign a community name, at the LCM prompt:
1. Type
community
2. Enter the old community name.
If one has not been assigned, you do not need to enter anything. LCM
prompts you for the new community name.
3. Enter the new community name.
LCM prompts you to verify the new community name by retyping it.
4. Retype the new community name.
Fast Network 10 User Guide
Assigning a Community Name
sxadminAnyPass
sets. The default password is an
SNMP
. You can then enter a
Page 3-15