Removing The Transmitter Head - Emerson Rosemount 3300 Series Reference Manual

Reference Manual
00809-0100-4811, Rev CA
February 2006
Removing the
Transmitter Head
FLANGE VERSION
Nut
Put the protection
plug here!
THREADED VERSION
Put the protection
plug here!
Rosemount 3300 Series
1. Loosen the nut that connects the
transmitter housing to the Process Seal.
2. Carefully lift the transmitter head.
3. Make sure that the upper surface of the
Process Seal is clean and the
Process Seal
spring-loaded pin at the center of the
Process Seal is properly inserted (the pin
should move back when pushed into the
hole).
4. Attach the protection plug to the Process
Seal.
NOTE
Do not remove the Process Seal from the
adapter!
Nut
Process Seal
Adapter
6-19