Adjusting The Fuser; Resetting Defaults - Xerox Phaser 6600 User Giude

Maintenance
1. At the printer control panel, press the Menu button.
Note: To navigate through the menu, use the Up or Down arrow buttons.
2. Navigate to Admin Settings, then press OK.
3. Navigate to Service Tools, then press OK.
4. Select Adjust TransRoll, then press OK.
5. To select the paper type for the adjustment, press the arrow buttons, then press OK.
6. To increase or decrease the amount of offset, press the arrow buttons, then press OK.
7. Repeat this procedure for each paper type you need to adjust.
8. To return to Service Tools, press the Back arrow button, or to return to the main menu, press the
Menu button.

Adjusting the Fuser

Use Adjust Fuser for optimum print quality across a wide range of paper types. If the toner on a print
is smearing or can be rubbed off the paper, increase the offset for the paper you are using. If the
toner is blistered or mottled, decrease the offset for the paper you are using.
To adjust the fuser:
1. At the printer control panel, press the Menu button.
Note: To navigate through the menu, use the Up or Down arrow buttons.
2. Navigate to Admin Settings, then press OK.
3. Navigate to Service Tools, then press OK.
4. Select Adjust Fuser, then press OK.
5. To select the paper type for the adjustment, press the arrow buttons, then press OK.
6. To increase or decrease the amount of offset, press the arrow buttons, then press OK.
7. Repeat this procedure for each paper type you need to adjust.
8. To return to Service Tools, press the Back arrow button, or to return to the main menu, press the
Menu button.

Resetting Defaults

Initializes the settings stored in the non-volatile memory (NVM) except for the network settings. The
NVM stores printer settings even after the power is turned off. After executing this function and
restarting the printer, all menu settings are reset to their default values.
To reset defaults:
130 Phaser 6600 Color Printer
User Guide