Aligning Your Interactive Whiteboard With Your Projector (Optional); Completing Your Installation - Smart Technologies SMART Board V280 Installation And User Manual

To align your
interactive whiteboard
with your projector
To complete your
installation
15 | I N S T A L L IN G A N D S E C U R I N G Y O U R S M A R T B O A R D V 28 0 I NT E R A C T I V E
W H I T E B O A R D
Aligning Your Interactive Whiteboard with Your Projector
(Optional)
If your projector is installed in a fixed location, align your interactive whiteboard
to the projected image before you secure the L-shaped tabs.
1. Install or position your projector on a projector
platform or stand if necessary, and then turn it
on and point the lens of your projector at the
center of your interactive whiteboard's screen.
2. Make fine adjustments to the image size, level
and focus of the projected image, according
to your projector manufacturer's instructions.
3. Slide your interactive whiteboard sideways on
its bracket to align it with the projected image.
4. Repeat steps 2 and 3 until your interactive
whiteboard is properly aligned.
A correctly aligned image fits squarely on your interactive whiteboard's screen. Each
side of the projected image should extend almost to the edge of the display surface.

Completing Your Installation

Refer to the following procedure to finish installing your interactive whiteboard.
1. Push your interactive whiteboard securely
against the wall, and then slide each L-shaped
tab backward until it contacts the wall.
NOTE
Each of these tabs has an adjustment
range of 1/2" (1.5 cm) to accommodate
uneven wall surfaces.
3×