Fujitsu MAX3073NC - SCSI,80, Dell DC961,Hard Drive Scsi Logical Interface Specifications page 80

Command Specifications
f) AGD (AIP generation disabled)
This specifies whether or not it is permitted to generate AIP (Asynchronous Information Protection).
"1" * (Prohibited): Prohibited generation
"0" (Permitted):
g) ACE (AIP checking enabled)
This specifies whether or not it is permitted to check AIP (Asynchronous Information Protection).
"1" (Permitted):
"0"*(Prohibited): Prohibiting check
h) RTD (reselection timeout delay)
This specifies the reselection timeout delay time.
Bit 1
0
0
1
1
* Set at shipping time
i) Spindle motor start delay time
This specifies the time after power on until the motor starts.
The IDD's motor starts after [(value specified in this parameter) x (IDD's SCSI ID x 0.1)] seconds from the
power is switched on. If X '00' is specified in this parameter, the motor starts immediately after the power
is switched on, no matter what SCSI ID is set in the IDD. Also, the IDD starts the motor immediately no
matter what value is specified in this parameter.
This parameter is enabled only when set in the "Auto Motor Start Mode" with a setting terminal.
3-18
Permitted generation
* Set at shipping time
The IDD ignores this specification and operates with the settings
specified at shipping.
Permitting check
* Set at shipping time
The IDD ignores this specification and operates with the settings
specified at shipping.
Bit 0
0 250 [ms]*
1 3 [ms]
0 Reserved
1 Reserved
Reselection Time-out Delay
C141-C010