Fujitsu MAX3073NC - SCSI,80, Dell DC961,Hard Drive Scsi Logical Interface Specifications page 155

The logical block address of defective data blocks is described in 4-byte format in the defect descriptor.
When multiple defect descriptors are specified, it is best for the INIT to describe defect descriptors in the
ascending order of the logical data block addresses.
Furthermore, if the addresses of logical data blocks specified in the defect descriptor list overlap each
other, This command is terminated with a CHECK CONDITION status (ILLEGAL REQUEST [=5] /
Invalid field in parameter list [=26-00] and none of the alternate block allocation processing in that
command is executed.
The IDD allocates alternate blocks to the specified data blocks in order from the top of the defect
descriptor list. When all the usable spare sectors have been used up, and it is impossible to allocate
alternate blocks, execution of this command is terminated at that point and a CHECK CONDITION
status is reported. The sense data at this time indicate the following contents.
• Sense key:
• Additional sense code/
Additional sense code qualifier:
• "VALID" bit:
• Information field
• Command inherent information field
Also, when this command is terminated abnormally with a CHECK CONDITION status due to any one
of several other types of error besides the above error, the logical block address specified in the first
defect descriptor which did not undergo alternate block allocation is reported in the "Command inherent
information" field in the sense data. However, if alternate block allocation processing of the defect
descriptors for which alternate block allocation has not been implemented cannot be specified, or if
alternate block allocation of all the specified defect descriptors has been completed, the "Command
inherent information" field indicates X 'FFFFFFFF.'
When alternate block allocation processing is successful, the defect position information on the disk media
related to the data blocks specified in the defect descriptor list is recorded on the disk media as the defect list
(G List). The INIT can read the contents of the G List using the READ DEFECT DATA command. Also,
this command has no influence on the contents of the primary defect list (P List).
Note:
The defect position information in the G List is physical block addresses (logical data block
addresses are allocated when no defect exists on the disk media). Therefore, the values specified in
this command's defect descriptor list (logical block addresses) may not necessarily be the same as
the contents of the G List read by the READ DEFECT DATA command after this command is
terminated. For details, see the description of the READ DEFECT DATA command (Section 3.3.3).
Note: Precautions for use of command
If this command is terminated with a CHECK CONDITION status, the additional sense code/additional
sense code qualifier in the sense data is other than "No defect spare location available [=32-00], and a valid
logical block address (other than X 'FFFFFFFF') is displayed in the "Command inherent information" field,
it is necessary for the INIT to reissue this command by the following procedure after executing recovery
processing (shown in Section 5.2) in accordance with the contents of the sense data.
C141-C010
4 = HARDWARE ERROR
32-00 = No defect spare location available
"1"
Logical block address specified in the defect descriptor at
the point when alternate block allocation becomes
impossible.
3.3 Format Commands
3-93