Inquiry (12) - Fujitsu MAX3073NC - SCSI,80, Dell DC961,Hard Drive Scsi Logical Interface Specifications

Specifications
Hide thumbs Also See for MAX3073NC - SCSI,80, Dell DC961,Hard Drive:
Table of Contents

Advertisement

Command Specifications
3.1.2

INQUIRY (12)

Bit
7
Byte
0
1
LUN
2
3
0
4
5
0
This command transfers the information showing the IDD's characteristics (INQUIRY data) to the
application client. This command is executed immediately without queuing in a system which issues
only commands with no tags or links.
This command is executed normally even in cases where the UNIT ATTENTION condition is held, and
the UNIT ATTENTION condition is not cleared. This command is also executed normally when the
disk drive is not in the ready state or even when an illegal logical unit number (LUN) is specified.
A CHECK CONDITION status is reported for this command and it is terminated abnormally only in the
case that one of the following conditions is detected.
There is an error in the specifications other than the LUN field of the CDB.
It is impossible to send INQUIRY data because of an IDD hardware error.
An unrecoverable error was detected on the SCSI bus.
An error detected during command execution was recovered in the IDD's error recovery processing
(Retry), but the mode which reports "RECOVERED ERROR" is specified in the MODE SELECT
parameter.
Applicability to overlapping command exception conditions (See Section 1.7.1.)
The functions which can be specified in this command's CDB and the contents of information transferred
to the application client from the IDD differ depending on the specifications in the CHANGE
DEFINITION command. Furthermore, see Section 3.1.4, "CHANGE DEFINITION (40)" concerning
the CHANGE DEFINITION command.
If bytes 1, the "EVPD (enable vital product data)" bits, the "CmdDt (Command Support Data)" bits, and
byte 2, the "Page code" field in the CDB are enabled only in the case that transfer of the SCSI-2/SCSI-3
mode's INQUIRY data is specified. In the case of the SCSI-1/CCS mode, zero must be set in these bits
and in this field. And if both the "EVPD" and "CmdDt" bits are one, this command is terminated by a
CHECK CONDITION status (ILLEGAL REQUEST [=5] / Invalid Field in CDB [=24-00]).
3-2
6
5
4
0
Page Code/Operation Cpde
0
0
0
Transfer Byte Length
0
0
0
3
2
X'12'
0
0
0
0
0
0
1
0
CmdDt
EVPD
0
0
0
Link
C141-C010

Advertisement

Table of Contents
loading

This manual is also suitable for:

Maw3073Maw3147Maw3300Max3036Max3073Max3147 nc series

Table of Contents