Fujitsu MAX3073NC - SCSI,80, Dell DC961,Hard Drive Scsi Logical Interface Specifications page 265

Table 5.2
C* Q* Name
31 00 Medium format corrupted The media format is different from the original format. (The media
01 FORMAT command failed For some reason, formatting cannot be completed and reformatting
32 00 No defect spare location
available
01 Defect list update failure
37 00 Rounded parameter
3D 00 Invalid bits in IDENTIFY
message
3E 03 Logical unit failed Self-
Test
04 Logical unit unable to update The IDD failed to update the Self-Test result log
3F 01 Microcode has been changed Microcode was changed by another INIT.
02 Changed operating
definition
05 Device identifier changed
40 nn Diagnostic failure on
component "nn"
43 00 Message error
* C: Additional Sense Code,
C141-C010
Additional sense code and additional sense code qualifier (4 of 6)
was not formatted after the data format specification was changed by
the MODE SELECT command.)
is necessary.
No usable alternate block area exists. Or alternate block processing
cannot be performed due to control table overflow.
Updating of the defect list (G List) failed.
Rounding processing of the MODE SELECT parameter specified by
the command was performed.
"1" was specified in the reserve bit of the IDENTIFY message.
The test segment error occurred during the Self-Test
Operating definition was changed.
Device identifier was changed.
An error was detected in self-diagnosis. ("nn" is a Fujitsu unique
code)
• 81: Buffer RAM compare error/bus error
• 82: Program RAM compare error/bus error
• 83: HDC register check error
• 84: Firmware header/check sum error
• 85: Firmware type unmatch
• 86: Parameter header/check sum error
• 88: Drive Serial No. unmatch
• 89: DE type unmatch
• 8F: Other MPU peripheral circuit diagnostic error
• 92: Spindle motor firmware initialize error
A message sent by the IDD was illegally rejected.
Q: Additional Sense Code Qualifier
Explanation
5.1 Sense Data
Sense
key
3
3
4
4
1
5
4
4
6
6
6
4
B
5-9