Temperature Page (X'0D'); Temperature (Page 0D, Code 0000) - Fujitsu MAX3073NC - SCSI,80, Dell DC961,Hard Drive Scsi Logical Interface Specifications

Parameter Data Formats
The Counter Value indicates the count of all non-medium errors (01/xx/xx, 02/xx/xx, 04/xx/xx,
05/xx/xx, 06/xx/xx, 07/xx/xx, 09/xx/xx and 0B/xx/xx) posted to the interface.
Implementation:
If a non-medium error is posted, it will force a save of all error log pages information.
4.2.7

Temperature page (X'0D')

Bit
Byte
0
1
2
3
All of the following parameters have this header.
Page Length will be defined based on the value of Parameter Pointer. (CDB 5-6)

4.2.7.1 Temperature (Page 0D, Code 0000)

Bit
Byte
4
5
6
7
8
9
The Temperature sensed in the device at the time the LOG SENSE command is performed shall be
returned in the parameter code 0000h. The one byte binary value specifies the temperature of the device
in degrees Celsius. Temperatures equal to or less than zero degrees Celsius shall be indicated by a value
of zero. If a valid temperature cannot be detected because of a sensor failure or other condition, the
value returned shall be FFh. If EWASC (mode page 1C) is on, comparison is performed between the
temperature value specified in parameter 0000h and the reference temperature specified in parameter
0001h.
4-62
7 6 5
0 0 0
7 6 5
(MSB)
X'0000' (Parameter code)
(Temperature)
DU DS TSD
0 1 0
X'02' (Parameter Length)
Temperature (degrees Celsius)
4 3 2
0 1 1
X'00' (Reserved)
Page Length (MSB)
Page Length (LSB)
4 3 2
ETC TMC
0 0 0
X'00' (Reserved)
1 0
0 1
1 0
(LSB)
LBIN LP
1 1
C141-C010