Fujitsu MAX3073NC - SCSI,80, Dell DC961,Hard Drive Scsi Logical Interface Specifications page 264

Sense Data Error Recovery Methods
Table 5.2
C* Q* Name
1B 00 Synchronous Data
Transfer Error
1C 01 Primary defect list not found The defect list (P List) header is incorrect.
02 Grown defect list not found The defect list (G List) header is incorrect.
90 SA information list not
found
1D 00 Miscompare during verify
operation
80 Miscompare during self-
configuration
1F 00 Partial Defect List Transfer Read Defect Data command (37h) cannot transfer all the Defect data
20 00 Invalid command
operation code
21 00 Logical block address out
of range
24 00 Invalid field in CDB
25 00 Logical unit not supported An illegal LUN was specified.
26 00 Invalid field in parameter
list
04 Invalid Release of
Persistent Reservation
27 00 Write protected
29 01 Power on occurred
02 SCSI reset occurred
03 TARGET RESET message
occurred
05 Transciever mode changed
to Single-Ended
06 Transciever mode changed
to LVD
2A 01 Mode parameter changed
03 Reservations preempted
04 Reservations released
05 Registrations preempted
2F 00 Command cleared by
another INIT
* C: Additional Sense Code,
5-8
Additional sense code and additional sense code qualifier (3 of 6)
An errorr (timeout) was detected during synchronous data transfer
on SCSI bus by Synchronous Transfer Timeout function.
The SA information (MODE SELECT parameter) header is
incorrect.
Comparison of data transferred from the INIT by a VERIFY
command (when the Byte Check mode was specified) with data read
from the disk media was terminated unsuccessfully.
There is an unmatch to compare read data with write data during
self-configuration.
in the target because the numbers of defect exceeded the maximum.
CDB byte 0 (operation code) is illegal.
A logical block address which exceeds the drive's maximum value
was specified.
There is an error in a specification in the CDB.
There is an error in the parameter list specifications transferred from
the INIT during command execution.
There is unmatched valid reservation status in the parameter list
specifications
A write operation was attempted in a write protected area. Or a
write operation is prohibited at the external operation panel.
Power On occurred.
A SCSI RESET was received.
A TARGET RESET message was received.
Transciever mode was changed to Single-Ended mode.
Transiever mode was changed to LVD mode.
The MODE SELECT parameter values were changed by another INIT.
A persistent reserve state was cleared by another INIT.
A persistent reserve state was released
A persistent reserve state was prempted by another INIT.
A command was forcibly terminated by another INIT during
execution or queuing.
• By a CLEAR QUEUE message
• The sense hold state was entered when the QErr bit was set on "1."
• The DQue bit was changed from "0" to "1."
Q: Additional Sense Code Qualifier
Explanation
Sense
key
B
3
3
3
E
E
1
5
5
5
5
5
5
7
6
6
6
6
6
6
6
6
6
6
C141-C010