Fujitsu MAX3073NC - SCSI,80, Dell DC961,Hard Drive Scsi Logical Interface Specifications page 204

Parameter Data Formats
Bit
Byte
0
1
2
Default
Variable
3
Default
Variable
4
Default
Variable
5-9
10-11
Default
Variable
Figure 4.6
The error recovery parameters divided in this page descriptor are applicable for the following
commands.
•
VERIFY
•
WRITE AND VERIFY (verify operation)
Note:
If selecting the SCSI-1/CCS mode in the CHANGE DEFINITION command specification, use Page
code = 1 (Read/Write Error Recovery Parameters) instead of this parameter.
a. Error recovery flags
• EER (enable early recovery)
• PER (post error)
• DTE (disable transfer on error)
• DCR (disable correction)
The definitions and functions of these control flags are the same as for the read/write error recovery
parameters. See item (1) concerning the details.
4-20
7 6 5
0 0 0
X'0A' (Page Length)
(Reserved)
0 0 0
0 0 0
Number of retries during VERIFY.
Correctable Bit Length
X 'FF' (MAWxxxx) / (MAXxxxx) (= over 255 bits)
X'0000000000' (Reserved)
Recovery Time Limit
MODE SELECT parameters: verify error recovery parameters
4 3 2
0 0 1
EER PER
0 1 0
0 1 1
X'3F'
X'FF'
X'00'
X'7530'
X'FFFF'
1 0
1 1
(See the
Note.)
DTE DCR
0 0
1 1
C141-C010