Fujitsu MAX3073NC - SCSI,80, Dell DC961,Hard Drive Scsi Logical Interface Specifications page 263

Table 5.2
C* Q* Name
11 00 Unrecovered Read Error
01 Read retries exhausted
02 Error too long to correct
04 Unrecovered read error,
auto reallocation failed
13 00 Sync Byte not found for
Data field
14 00 Record entity not found
01 Record not found
15 01 Mechanical positioning
Error
02 Positioning Error detected
by read of medium
17 01 Recovered data with retries A data error was recovered from by reading was retried.
02 Recovered data with
positive head offset
03 Recovered data with
negative head offset
06 Recovered data without
ECC: data auto-
reallocated
08 Recovered data without
ECC: recommended
rewrite
18 00 Recovered Data with Error
Correction Applied
19 02 Defect list error in primary
list
03 Defect list error in grown list An error was detected during reading of the defect list (G List).
80 Log information read error
81 Log information write
error
84 Mode Select SA write
Error
Ax Drive Parameter SA write
Error
Bx Drive Parameter SA write
Error
1A 00 Parameter list length error There is a mistake in the indication of the parameter list page length.
* C: Additional Sense Code,
C141-C010
Additional sense code and additional sense code qualifier (2 of 6)
Unrecovered read error occurs during reading data field (LBA
Miscompare Error detected by SCSI portion)
Unrecovered error was detected during data read (retry out).
Unrecovered error was detected during data read (BCRC error
detected by SCSI)
Auto allocation failed during read.
SB (Sync Byte) could not be detected in the Data area.
Expected data from a sector was undetected. (LBA compare error
detected by FMT)
The target data block (sector) could not be detected.
A seek error occurred in the drive.
LBA did not match due to Cylinder number's mismatch.
A data error was recovered by read retry with offsetting head to
positive direction.
A data error was recovered by read retry with offsetting head to
negative direction.
Automatic alternate allocation was applied without ECC correcting a
data error.
Rewriting to the same sector was performed without ECC correcting
a data error.
A data error was recovered by read retry with ECC corrercting.
An error was detected during reading of the defect list (P List).
An error was detected during reading of statistical information.
A write error was detected during writing of statistical information.
An error was detected during writing of SA information (Mode
Select Paramenter)
An error was detected during writing of SA information (Device
Information)
An error was detected during writing of SA information (Device
Information)
Q: Additional Sense Code Qualifier
Explanation
5.1 Sense Data
Sense
key
3
3, B
3, B
3
1, 3, B
1, 3, B
1, 3, B
1, 3, B
1, 3, B
1
1
1
1
1
1
3
3
3
3
3
3
3
5
5-7