Table 5.4 Error Recovery Processing Procedures - Fujitsu MAX3073NC - SCSI,80, Dell DC961,Hard Drive Scsi Logical Interface Specifications

Sense Data Error Recovery Methods
K* C* Q*
B 4E 00 Overlapped commands attempted
4D nn Tagged overlapped commands
E 1D 00 Miscompare during verify operation
* K: Sense Key
Q:
Additional Sense Code Qualifier
Table 5.4
Recovery
Method
0 It is not necessary to perform the error recovery processing. Continue processing.
1 Error recovery processing is impossible. Terminate processing.
2 This is a programming error and error recovery processing is impossible. Terminate
processing and correct the error in the system (INIT) programming.
3 This is an error in the SCSI protocol and error recovery processing is impossible. Terminate
processing and check the system's SCSI bus operation.
4 1) Reissue the original command. (Retry)
2) If the command is terminated with the same error when retried, perform recovery
method 3 or 1.
3) If the command is terminated with a different error when retried, execute the recovery
processing procedure for that error.
5-18
Table 5.3 Sense data error classification (4 of 4)
Error contents
Before execution of a command was completed, a
new command was issued by the same INIT.
Data failed to match in the Byte check mode of the
Verify command.
C: Additional Sense Code
L: Logging Necessary? (shown in Section 5.2.3)
Error recovery processing procedures (1 of 5)
Recovery Processing Procedure
Recovery method
L*
(See Table 5.4.)
None 2
None 24
C141-C010