Table of Contents
Advertisement
Installation and Administration Guide
Configure the default settings to apply to
specific user accounts
After you select the user accounts that you want to move to the destination MDM domain, you can apply different settings
for the destination BlackBerry Enterprise Server, group, IT policy, and software configuration to the user accounts that you
want to move.
If you enable bulk mode and configure custom default settings to apply to individual user accounts, the destination
BlackBerry Administration Service must process the different settings for each user account. As a result, the migration
process might take longer than expected to complete. If you enable bulk mode, it is a best practice to configure a single
default setting to apply to all user accounts. You can modify the IT policy, software configuration, and group assignments
using the BlackBerry Administration Service after the migration is complete. If you want to assign custom default settings
to individual user accounts as part of the migration process, it is a best practice to use live mode.
Before you begin:
•
In the destination MDM domain, create the groups, IT policies, and software configurations that you want to apply to
the user accounts.
•
Configure the source and destination instances of the BlackBerry Configuration Database.
•
Before you select the user accounts that you want to move to the destination MDM domain, in the Step 3: Manifest
Configuration section, in the Summary section, click Details. Clear the Use current defaults for all new entries check
box.
•
Select the user accounts that you want to move to the destination MDM domain.
1.
In the BlackBerry Enterprise Transporter, in the Step 3: Manifest Configuration section, in the Summary section,
click Details.
2.
In the Default Destination Assignments section, click the BlackBerry Enterprise Server, group, IT policy, and
software configuration that you want to apply to the user accounts.
3.
Perform one of the following actions:
•
To apply the selected default settings to specific user accounts, select the user accounts. Click Apply to selected.
•
To apply the selected default settings to all user accounts that do not have values for the default settings
specified, click Apply to blank cells.
•
To specify the default settings for a specific user account, configure the values for the Dest Server, Dest Group,
Dest Policy, and Dest SW Config drop-down lists for the user account.
4.
If necessary, repeat steps 2 and 3 to apply different default settings to specific user accounts.
5.
Click Done.
52
Selecting the user accounts to move to the destination MDM domain
Advertisement
Table of Contents
Troubleshooting
