Jammed Paper Remove Door Sensor (Pc1) Removal; Transport Motor (M1) Removal - Epson EPL-N2700 Service Manual

EPL-N2700 Optional Units
4.2.8 Jammed Paper Remove Door Sensor (PC1)
Removal
1. Remove the Rear Cover. (Refer to Section 4.2.2.)
2. Remove the Control Board. (Refer to Section 4.2.6.)
3. Release the harness from the cable clamp in the bracket.
4. Remove six screws (3501) securing the bracket to the unit frame
and remove the bracket.
5. Remove the screw (3501) securing the bracket for the Bin 4/Bin 5
Switch Solenoid to the unit frame and remove the bracket along with
the Jammed Paper Remove Door Sensor.
6. Remove the stopper attaching the Jammed Paper Remove Door
Sensor to the bracket.
7. Release the hook on the Jammed Paper Remove Door Sensor and
remove the sensor from the bracket.
8. Disconnect the harness from the connector on the Jammed Paper
Remove Door Sensor.
5-Bin Unit

4.2.9 Transport Motor (M1) Removal

1. Remove the Rear Cover. (Refer to Section 4.2.2.)
2. Disconnect the harness for the Transport Motor from the connector
3. Release the harness from the harness clamp located below the
4. Remove two screws (3501) securing the Transport Motor to the
Disassembly and Assembly of the 5-Bin Unit
on the Control Board.
Transport Motor.
bracket and remove the motor.
Figure 4-18. Transport Motor Removal
When installing the bracket for the Transport Motor to
the Unit Frame, make sure the gear 24T in the Bin 1
Guide and the gear 22/29T in the Transport Motor Unit
are engaged.
Revision A
84