Lcc Paper Take-Up Sensor (Pps0) Removal; Paper Empty Sensor 1 (Pps1) Removal; Paper Empty Sensor 2 (Pps2) Removal - Epson EPL-N2700 Service Manual

EPL-N2700 Optional Units

3.2.3.7 LCC Paper Take-up Sensor (PPS0) Removal

1. Remove the Paper Take-up Unit. (Refer to Section 3.2.3.)
2. Remove the shoulder screw securing the LCC Paper Take-up
Sensor to the Paper Take-up Unit and remove the sensor.
3. Disconnect the harness from the connector on the LCC Paper Take-
up Sensor.

3.2.3.8 Paper Empty Sensor 1 (PPS1) Removal

1. Remove the Paper Take-up Unit. (Refer to Section 3.2.3.)
2. Remove the tension spring set between the paper take-up roller act
arm and Paper Take-up Unit.
3. Sliding the paper take-up roller act arm to the left, release the arm
from the connection pin on the Paper Take-up Unit, and remove the
link arm.
4. Remove the shoulder screw securing the Paper Empty Sensor to
the Paper Take-up Unit and remove the sensor.
5. Disconnect the harness from the connector on the Paper Empty
Sensor 1.

3.2.3.9 Paper Empty Sensor 2 (PPS2) Removal

1. Remove the Paper Take-up Unit. (Refer to Section 3.2.3.)
2. Remove the shoulder screw securing the Paper Empty Sensor 2 to
the Paper Take-up Unit and remove the sensor.
3. Disconnect the harness from the connector on the Paper Empty
Sensor 2.
LCC Unit
Paper Empty Sensor 2 (PPS2)
Paper Take-up Unit
Disassembly and Assembly of the LCC Unit
Paper Take-up Roller Act Arm
Paper Empty Sensor 1 (PPS1)
Figure 3-21. Sensor Removal
(LCC Paper Take-up Sensor, Paper Empty Sensor 1 and 2)
Revision A
Tension Spring
Link Arm
Shoulder Screws
LCC Paper Take-u
Sensor (PPS0)
Shoulder Screw
46